Socket 7Ci

Videos

1. Check if the scanner is 7Ci or not.
2. Pair with an Android phone.
   
3. Pair with an iPhone
   

Please follow the instructions below to connect your Socket 7Ci scanner to your phone:

1. Go to Settings -> Bluetooth*from your phone, then disable Bluetooth on your phone. This will ensure the scanner is *NOT connected to the phone during the factory reset or configuration of the scanner. If the scanner is still connected to your phone, you cannot scan the command barcode to perform a factory reset or configure the scanner.

2. Turn on the scanner by pressing and holding down the small power button (right below the big oval trigger button) until you hear a beep. You will see the blue light blinking on the top.
3. Scan the factory reset barcode below. The scanner will beep several times and turn off. This is an essential step to put the scanner in an initial state, esp. if the scanner has been used with another phone before.

4. Turn the scanner on again and scan the barcode below to put the scanner into HID-Keyboard (default) mode. This is the easiest pairing mode between scanner and phone. For other pairing modes, please consult the user manual and Socket support.

5. To disable scanner sound, turn off the Bluetooth on your phone to disconnect the scanner, then scan the command barcode below.

6. To disable scanner vibration, turn off the Bluetooth on your phone to disconnect the scanner, then scan the command barcode below.

7. Turn on the Bluetooth and Connect the scanner to your phone. Navigate to Settings -> Bluetooth. Turn the Bluetooth and search the device (a). If you find the Socket in the device list, tap it to connect (b).
   

If you have trouble scanning the barcodes above, you can print out this document and scan.

Complete documents for all Series 7 scanners can be found here .